sending buffer

英 [ˈsendɪŋ ˈbʌfə(r)] 美 [ˈsendɪŋ ˈbʌfər]

【计】发送缓冲器

计算机



双语例句

  1. You really want to bump this up from the default, because if its limit is reached, the sending application suspends data transfer until TCP sends the data to the buffer.
    您可能希望使其超过默认值,因为如果达到了限制值,发送应用程序则将挂起数据传输,直到TCP将数据发送到缓冲区为止。
  2. Both provide a means to tell a sending endpoint that it should "buffer" messages when the transport back channel is not available.
    都提供了相应的方法来告知发送端点应该在传输回发通道不可用的情况下“缓存”消息。
  3. If the transport layer agent has the functions of sending and receiving the real data, then the buffer area is needed.
    如果传输层代理具有发送和接收真实数据的功能,那么就需要具有缓冲区。
  4. The package wizard is effectively sending keystrokes to a buffer with the intend of performing edits.
    为了执行编辑,包向导不断地发送按键到缓冲区。
  5. In the server design, applies two forwarding modes of partial packet and entire packet forwarding, and the dynamic water level of sending buffer.
    采用了立即转发和完整转发两种转发模式,以及动态调整发送缓冲区水线的发送模式。
  6. This paper first provides the transaction committing flow chart of a distributed multidatabase system architecture. Then it gives the database design of the sending buffer and receiving buffer, and describes the relations among the tables.
    首先给出了一种分布式多数据库系统结构的事务提交流程,其次对数据通讯的发送缓冲和接收缓冲进行了数据库设计,对其中的关系进行了描述。
  7. Implemented the sending of custom-built ARP detecting frame and reading of ARP buffer by coding, and fixed the discovery results of devices using corresponding algorithm; Moreover I implemented the distributed discovery of message based on ARP protocol.
    编码实现了定制ARP探测帧的发送和ARP缓存的读取,并用相应算法确定设备的发现结果:并使用RMI技术实现了分布式的基于ARP协议报文发现。
  8. The data in the sending buffer is sorted by global transaction, site and SQL order; and the data in the receiving buffer is stored as the same order and is packed to execute under the basic unit the sub-transaction of the physical site.
    对于发送缓冲,它以事务、节点和SQL语序的顺序排序并传输,接收缓冲以同样的顺序存放并以子事务为基本单位执行。
  9. Based on the analysis of TCP-friendly congestion control mechanism, a TCP-friendly and RTCP feedback-based congestion control mechanism was proposed. The ratio of dropped packet was analyzed by Kalman filter to forecast the status of network load. The sending rate was adjusted by setting up the buffer.
    通过对丢包率进行卡尔曼过滤分析预测网络负载状况,结合接收缓冲区大小设置来平滑发送速率,在分析TCP友好拥塞控制的基础上,提出了一种基于RTCP反馈的TCP友好拥塞控制机制。
  10. Sending Windows Message by Buffer Overflow Technique
    利用缓冲区溢出技术强行推送信使
  11. This paper analyzes the structure of TCP sending buffer, then proposes a dynamic approach to allocate TCP sending buffer in order to guarantee TCP connection working under the maximum available bandwidth.
    :分析了TCP发送缓冲区的结构,并提出一个动态分配TCP发送缓冲区的方法,保证TCP连接以最大有效带宽发送数据。
  12. The link layer communication software in the lower layer sends data in the sending buffer to the air at the appropriate time, and receives data from the air interface and takes it into receiving buffer.
    下层的链路层通信软件在合适的时间将发送缓冲区的数据发送到空中,并将从空中接收到的数据放入接收缓冲区。
  13. Simulation results show that sending rate of the source and buffer of branch node, which are calculated in the paper, is very important for actual network environment.
    仿真结果表明,理论计算出的源端发送速率和分支节点缓冲占有量的值对实际的网络环境有一定的指导意义。